Spur Gear, 52t Mod 1 Steel for E Revo 2 XO-1 - Hot Racing

About this part

Hot Racing 52 tooth hardened steel spur gear, 1.0 modulus (1.0 metric pitch). Made for the TRA E-Revo 2 (6S and 8S), X-Maxx, Pro Scale 2WD Sand Car and XO-1.

Features

• CNC machined hardened steel
• Black oxide finish
• Laser etched tooth count
• IN THE BOX:
• One (1) 52 tooth, 1.0 modulus steel spur gear
• BEFORE YOU BOLT IT:
• Do NOT use the pin system for gear mesh. Set it by hand instead, following the TRA manual (ref. pg.22, Adjusting Gear Mesh).
• Pull the pins and loosen the four 4x16mm button-head cap screws on the bottom. Run a narrow strip of notebook paper into the mesh, slide the motor and pinion into the spur, then tighten the four screws and pull the paper. A fresh strip should slide through without binding.
• SPECS:
• Overall diameter: 54mm
• Gear face width: 8mm

Fits