Diff Ring/Pinion, Steel Helical Underdrive (10/35T) for TRX4 - Hot Racing

About this part

Hot Racing's steel helical underdrive gear set for the 1/10 TRA TRX-4. The 35T/10T setup gives 9% overdrive for faster wheel speed and is a common pick for front digs. The helical cut runs smoother and wears slower than stock straight cut bevels.

Features

• Precision machined helical spiral cut gears, stronger and smoother than factory straight cut bevel gears
• High carbon steel construction
• Less vibration, noise and wear than stock straight cut bevel gears
• 35T/10T provides 9% overdrive (vs. stock 34T/11T) to increase wheel speed, commonly used up front for digs
• Works on front or rear. Commonly run front and rear together, or rear only to boost front digs

You will receive

• One (1) 35 tooth spiral cut ring gear
• One (1) 10 tooth spiral cut pinion gear

Requirements

• Install per the kit manual
• Medium threadlock (blue threadlocking compound) if screws thread into metal
• Hot Racing SPL10G05 high temp grease recommended

Comments

• Replaces TRA8288. Option: overdrive the front axle and underdrive the rear axle.
• Combination One: TRXF312 front, TRXF9411 rear.
• Combination Two: TRXF9411 front, TRXF9510 rear.
• Combination Three: TRXF312 front, TRXF35810 rear.

Fits

Replaces stock part