Rod Ends, Machined, Straight M4, Clear - Vanquish Products

About this part

A rebuildable upgrade for traditional molded rod ends. Built on the design style of our machined trailing arms, these use an adjustable tension system to hold the pivot ball. No pressed design here. An M2.5 set screw pushes on the tension piece, so you can re-tighten as parts wear. They replace the Incision rod ends (IRC00010) with no change to overall link length. YOU RECEIVE: 4 machined rod ends 4 brass tension set pieces 4 M2.5 set screws (0.05in driver required) 4 pivot balls 1 assembly instruction sheet

Notes

• Because machined and molded rod ends assemble differently, these may not cinch down and may rotate slightly once installed.
• Use a small amount of threadlock on the M2.5 set screw. Too much makes it hard to remove.
• No threadlock needed on the M4 threads when installing onto the link.
• Patience is required during assembly due to the small components.
• FITS:
• HPI Nitro RS4 (belt) (really old), HPI Nitro RS4 Nitro MT, Associated Rival Mini Monster Truck, Associated RC-8T3e, Losi 1:10 Baja Rey 4WD Desert Truck, Traxxas Boat DCB M41 Catamaran

Fits