About this part
Hot Racing 50 tooth hardened steel spur gear, 1.0 mod (1.0 metric pitch). Built for the TRA E-Revo 2 (6S and 8S), Maxx, Maxx Slash, X-Maxx, X-Maxx 8S, Pro Scale 2WD Sand Car and XO-1 XRT.
Features
- CNC machined hardened steel
- Black oxide finish
- Laser etched tooth count
- IN THE BOX:
- One (1) 50T, 1 mod steel spur gear
- BEFORE YOU BOLT IT:
- Skip the pin system for gear mesh and set it by hand. The TRA manual covers it on pg.22, Adjusting Gear Mesh.
- Pull the pins and loosen the four 4x16mm button-head cap screws on the bottom. Run a narrow strip of notebook paper into the mesh, slide the motor and pinion into the spur gear, then tighten the four screws and pull the paper. A fresh strip should slide through without binding.
- SPECS:
- Overall diameter: 52.8mm
- Gear face width: 8mm
Note
- Upgrade for factory plastic 6448 or 6448X 54T spur gear
