About this part
Hot Racing 54 tooth hardened steel spur gear, 1.0 modulus (1.0 metric pitch). Fits the TRA E-Revo 2 (6S and 8S), Maxx 4S, Maxx Slash, X-Maxx, X-Maxx 8S, Pro Scale 2WD Sand Car and XO-1.
Features
- CNC machined hardened steel
- Black oxide finish
- Laser etched tooth count
- IN THE BOX:
- One (1) 54 tooth, 1.0 modulus steel spur gear
- BEFORE YOU BOLT IT:
- Do NOT use the pin system for gear mesh. Set it by hand instead, following the TRA manual (ref. pg.22, Adjusting Gear Mesh).
- Pull the pins and loosen the four 4x16mm button-head cap screws on the bottom. Run a narrow strip of notebook paper into the mesh, slide the motor and pinion into the spur, then tighten the four screws and pull the paper. A fresh strip should slide through without binding.
- SPECS:
- Overall diameter: 56.8mm
- Gear face width: 8mm
Note
- Replaces TRA plastic 6449 or 6449X 54T spur gear
